• Miniker 102 manual

2 Miniker model programming

• 2.1 General structure of the code
• 2.2 Miniker programming illustrated
• • 2.2.1 All you need to know about mortran and cmz directives
  • 2.2.2 Entering model equation and parameters
• 2.3 Setting and running a model
• • 2.3.1 Setup a model and compile with cmz
  • 2.3.2 Setup a model and compile with make
  • 2.3.3 Running a simulation and using the output
  • 2.3.4 Doing graphics
• 2.4 Controlling the run
• • 2.4.1 Executing code at the end of each time step
  • 2.4.2 Controlling the printout and data output

Miniker works by combining the model specification code given by the user and other source files provided in the package. The code is assembled, preprocessed, compiled, linked and the resulting program can be run to produce the model trajectory and dynamic analysis.

The code provided in the package contains a principal program, some usefull subroutines and pieces of code called sequences combined with the different codes. Among these sequences some hold the code describing the model and are to be written by the user (sequences are similar to Fortran include files).

This document was generated on May 20, 2012 using texi2any.